Instant alert wireless driveway alarm
This has to be one of the most useful alarms we have seen for a long time. It
comprises two units, a transmitter and a receiver.
The transmitter is battery operated and designed to be site outdoors across a
driveway or area you wish to protect. The built in PIR will detect people and
cars moving across in front of the detector, effective range about 6-7 metres.
In the event of the unit being triggered the transmitter will send a radio
signal to the receiver which can be sited up to 100m away!
The receiver is also battery operated but can be used with a plug in powers
supply if required.
The receiver will emit a loud alarm sound for approx 5 secs when a signal is
detected from the transmitter. It also features am LED that will remain
illuminated until the reset button is pressed.
Transmitter measures 130x80x60mm
Receiver measures 130x80x40mm both units are designed to wall or post
mount.
Receiver runs on 3 AA batteries, transmitter on 1 PP3.
We have tested these units outside (ie no obstructions, line of sight) and achieved
a maximum range of 100m. This range will reduce considerably if you introduce
obstructions (eg walls etc)
build_table('tricks',array('DWA')); ?>
Motion detecting croaking frog
Somewhat unusual item, probably best suited to your garden or possibly on
your desk. The 'frog' will croak when someone (or something) moves in front of
it. Quite large (200x220x90mm) and supplied with a Lilly pad for total
authenticity!! 2xAA batts required.
build_table('tricks',array('XMFROG')); ?>
pir security switches from just £4.39
These brand new swivel
mounting PIR units will switch up to 2 kilowatts. Adjustable sensitivity, light
level and time delay (9 seconds to 10 minutes), 15m detection range, mains
operated, waterproof.
build_table('tricks',array('PIR1PACK')); ?>
build_table('tricks',array('PIR5PACK')); ?>
build_table('tricks',array('PIR10PACK')); ?>
PIR PCB
Click to enlarge
<>Just in are these bargain PCB's
fitted with a standard PIR detector and control electronics. 12vdc operation. If you use
one of these units 'as is' it gives you a thin beam detector. We played about with some
units like this before and got some very long range performance.Pyroelectric Infra-Red Detector Information V. 1.01
This module is designed to pick up thermal infra-red signals caused by a moving heat source.
Typically, this would be a human, however this type of sensor will respond to any moving heat source with well defined edges.
The outputs of the module are :-
1) On-board "detect" LED
2) Open Collector output (see diagram)
3) High impedance output (see diagram)
The module has an on-board voltage regulator which enables it to operate from 10 up to approx. 14 volts without damage. 12 volts is the recommended supply.
It is important to note that the open collector output is taken from just before the LED driver transistor ; this means that with no resistor between the output and Vcc the LED *will not work* !
This resistor should be 1000 ohms for 12V operation. (see diagram) In its present form, this sensor has limited range (typically a few cm) and is highly erratic due to swamping.
It has been discovered that adding a non-conductive cylinder to the bare sensor, the range may be extended.
This must be of a material which is opaque to thermal infra-red; the approximate dimensions are 13mm length by 5mm diameter .
The approximate range of the modified sensor is 10 feet over a 10 degree viewing angle; this could be extended over a wider range with a Fresnel lens but with reduced sense distance.
The connections for the PCB are shown in the attached diagram. The on-board output stage is not capable of driving a large (>40 mA) load, however the output from pin 3 may be fed via an inverter (using 4000 series logic) to other circuitry.
One idea is to use the "narrow beam" facility to act as a door counter ; this would be simple to implement by wiring the output to a decimal counter.
Another idea is to use the sensor to automatically ring a doorbell . As we have got rather a lot of these
we are selling them in packs of 4 for just £6
build_table('tricks',array('PIR8')); ?>
12v operated
smoke bombs!
Exclusive to Bull Electrical is this new kit that
will fill a room completely full of smoke in a few seconds! Not only that but you can
trigger the unit with a simple 12v DC supply!
Type 1
This includes a 12v triggering module and 20 smoke
canisters. Each canister will fill a large room in a very short space of time!
20 smoke canisters 1 trigger module
build_table('tricks',array('SB1')); ?>
Type 2
This includes a smaller smoke canister than type 1,
more suited to equipment 'fires'? etc.
20 small smoke canisters 1 trigger module.
build_table('tricks',array('SB2')); ?>
Type 3
This includes a 12v triggering module and 3 smoke
canisters. Each canister will fill a large room in a very short space of time!
3 smoke canisters 1 trigger module.
build_table('tricks',array('SB3')); ?>
build_table('tricks',array('SB4 ')); ?>
build_table('tricks',array('SB5 1')); ?>
build_table('tricks',array('SB6')); ?>
Don't drop
one in somebody's barbecue!
|
SolarGuard
dial-up wire free burglar alarm system |
A
totally wire free multi-zone security system with amazing 2 way
dial-up features |
|
|
|
The SolarGuard SG4000 system is a feature packed
security system for any home, office, or utility building. It is factory
set for you and basic security functions can be achieved in a matter of
minutes requiring only a simple keypad code change.
2 way dial up allows you to set the system to call your
mobile or office (4 locations max.) should the system be activated. You
can also dial-up at any time your alarm and check status and listen in
to your property.
build_table('tricks',array('tensg4000')); ?>
|
|
|
Incredibly
easy to install - this alarm system can be up and running in
around an hour |
|
Radio
technology for a secure installation and easy operation |
|
Solar
technology provides an extremely long operational lifespan of 10
years + |
|
No
messy wiring around your home |
|
Dial
in and listen to activity in your home at any time (pin code
protected for privacy) |
|
Know
imediately if a burglery is taking place at your property |
|
7
Zone operation |
|
|
System
Range |
20-30
Metres (Range Extender ET-01 available) |
|
Security
Code |
4
Digit (10000 Combinations) |
|
|
Other
Batteries(Included) |
Siren
(6V Sealed Lead Acid), Panel (12V Sealed Lead Acid) |
|
|
Zone
behaviours |
Instant,
Entry/Exit, Walkthrough, Chime and Panic |
|
|
Site
Code |
9
Bit (512 Combinations) |
|
|
PIR
Detection Range |
12m |
|
|
Battery
Life |
Sensors:
1-3 Years, Control Panel and Siren: 3 Years |
|
|
Frequency |
418MHz |
|
|
Sensor
Batteries (Included) |
PIR
(2x9V PP3), MDT (12V A23), Remote (12V A23) |
|
|
SolarGuard
Multi-Zone Wirefree Alarm System |
A
Complete 100% wirefree multi-zone alarm system |
|
|
|
Our SolarGuard Multi-Zone control panel based system is
the best of the bunch combining the latest zoning abilities with a
totally wire-free operation.
Incorporating the revolutionary MU5850 control panel
means you also get flexible operation including the ability to exit
through other doors, and a dedicated chime zone - a great feature for
protecting doors, garages and sheds at night.
As well as twin sirens fitted to the external SolarGuard
it provides a built-in siren on the control panel which features
entry/exit warning beeps and a useful audible test mode for checking
detectors.
build_table('tricks',array('tensg5850')); ?>
|
|
|
All
batteries included |
|
1
Wirefree Door/Window contact included |
|
2
PIR detectors included - and add as many as you like! |
|
Convenient
handheld remote control included |
|
7
Zone Control Panel with battery back up |
|
Solar
power keeps the bellbox battery charged for up to 3 years |
|
100%
Wirefree |
|
Fully
upgradable |
|
|
System
Range |
20-30
Metres (Range Extender ET-01 available) |
|
Security
Code |
4
Digit (10000 Combinations) |
|
|
Other
Batteries(Included) |
Siren
(6V Sealed Lead Acid), Panel (12V Sealed Lead Acid) |
|
|
Zone
behaviours |
Instant,
Entry/Exit, Walkthrough, Chime and Panic |
|
|
Site
Code |
9
Bit (512 Combinations) |
|
|
PIR
Detection Range |
12m |
|
|
Battery
Life |
Sensors:
1-3 Years, Control Panel and Siren: 3 Years |
|
|
Frequency |
418MHz |
|
|
Sensor
Batteries (Included) |
PIRs
(9V PP3), MDTs (12V A23), Remote (12V A23) |
|
|
Operating
Modes |
Disarm,Arm,Part
Arm,Battery Check (Tamper Disable) |
|
|
Complete
Wireless Alarm System |
An
installers favorite - this alarm incorporates fully wirefree sensors
with a traditional hard wired bellbox. |
|
|
|
|
For those who cannot resist the temptation to go
wireless this system incorporates both wired and wireless technology.
Whilst the detectors are fully wireless and the control
panel operates from remote control, the external siren unit retains that
traditional wired connection.
Upgrade this system with the ST01 Xenon Strobe Unit and
it latches and remains flashing in the event the system is triggered -
just like the wired systems.
build_table('tricks',array('TENSG1100ARM2')); ?>
|
|
|
2
PIR detectors included - and add as many as you like! |
|
Convenient
handheld remote control included |
|
100%
Wirefree Sensors |
|
7
Zone Control Panel with battery back up |
|
1
Wirefree Door/Window contact included |
|
All
batteries included |
|
Wired
bellbox has full tamper protection and battery backup |
|
Fully
upgradable |
|
|
System
Range |
20-30
Metres (Range Extender ET-01 available) |
|
Security
Code |
4
Digit (10000 Combinations) |
|
|
Other
Batteries(Included) |
Siren
Backup(6V Sealed Lead Acid), Panel Backup(12V Sealed Lead Acid) |
|
|
Zone
behaviours |
Instant,
Entry/Exit, Walkthrough, Chime and Panic |
|
|
Site
Code |
9
Bit (512 Combinations) |
|
|
PIR
Detection Range |
12m |
|
|
Battery
Life |
Sensors:
1-3 Years, Control Panel and Siren: 3 Years |
|
|
Sensor
Batteries (Included) |
PIRs
(9V PP3), MDTs (12V A23), Remote (12V A23) |
|
|
Frequency |
418MHz |
|
|
Operating
Modes |
Disarm,Arm,Part
Arm,Battery Check (Tamper Disable) |
|
|
100%
Wirefree Alarm System |
Get
your home protected easily and quickly with our remote control
operated wirefree alarm system |
|
|
|
SolarGuard is the original solar powered wire free alarm
AEI Security and was first registered with the UK patent office in 1996.
You choose how you want to configure your system and
dont worry about changing your mind later because weve designed this
kit to be upgraded to full control panel operation.
Buy this system and you are on the right road to
protection regardless of what you choose in the future.
build_table('tricks',array('ten5850bb12')); ?>
|
|
|
100%
Wirefree - no wiring at all! |
|
Add
as many wirefree sensors as you require |
|
Fully
expandable to control panel operation using the MU6450TX |
|
Can
be set up in under 1 hour |
|
Complies
with British Standards BS6706 and BS6799 Class 1 to Class IV Part A |
|
Full
tamper and radio jamming protection |
|
No
extras needed - ready to set up out of the box |
|
Can
be set up in under an hour |
|
Remote
control operated for ease of use |
|
Comes
complete with PIR movement detector, 2 magnetic door contacts and
remote control |
|
|
System
Range |
20-30
Metres (Range Extender ET-01 available) |
|
Security
Code |
4
Digit (10000 Combinations) |
|
|
Other
Batteries(Included) |
Siren
Back-up: 6V Sealed Lead Acid |
|
|
Zone
behaviours |
Instant,
Entry/Exit, Walkthrough and Panic |
|
|
Site
Code |
9
Bit (512 Combinations) |
|
|
PIR
Detection Range |
12m |
|
|
Battery
Life |
Sensors:
1-3 Years, Siren: 3 Years |
|
|
Sensor
Batteries (Included) |
PIRs
(9V PP3), MDTs (12V A23), Remote (12V A23) |
|
|
Frequency |
418MHz |
|
|
Operating
Modes |
Disarm,Arm,Battery
Check (Tamper Disable) |
|
|